Features
- 1680D ballistic polyester is abrasion resistant
- Holds Channellocks®, pliers, wrenches, radios, and cell phones, and more
- Two exterior D-rings for tool lanyard attachment
- Elastic strap with modular buckle closure secures contents of the holster
- Modular buckle connection system on back for easy attachment and removal to fall protection harnesses and tool belts
- Reflective strip for safety and visibility
- Nickel-plated storm drain™ for ventilation
- Maximum safe working capacity: 5lbs (2.3kg)
- Third-party certified to a 2:1 (dynamic) and 5:1 (static) safety factor
- 4.5in L x 2.5in W x 8.5in H (11cm x 6cm x 22cm)
- Patented design
Application
- Construction
- Telecommunications
- Oil & Gas
- Power generation
- Utilities
- Wind Energy
- Manufacturing
- Municipalities
- Scaffolding
California Residents: read Proposition 65 warning.
GEAR IN ACTION
Customer Ratings and Reviews
-
Tenacious
TesterKirk
Unless your "small" tool is a lock cutter, you can fit a whole handful of tools in this! The material is very thick and sturdy so it never collapses in on itself. The belt loop part is very long but makes it very easy to put on without having to take off your belt first. However, the plastic buckle on the belt loop could probably stand to be a little bigger, especially if you are wearing gloves. Fyi, there are two smaller internal pockets which can hold a needle nose or a wire stripper nicely. The elastic hold down band is a very neat touch but since the tool holder is a bit wide, the single bungee may not cover the whole area, so maybe two would be a little more secure. The dual D-rings seem a bit much both in size and in quantity, plus I think I'd rather have the "D" pointing down instead of to the sides. There is a little retro-reflective accent on top but would rather it be at the bottom as the top can get covered by clothing or a vest. And in Ergodyne fashion, little details are observed such as a air/drain hole at the bottom.
Please Note: This review is of product that was provided to the user free of charge.
-
Tenacious
TesterKirk
Unless your "small" tool is a lock cutter, you can fit a whole handful of tools in this! The material is very thick and sturdy so it never collapses in on itself. The belt loop part is very long but makes it very easy to put on without having to take off your belt first. However, the plastic buckle on the belt loop could probably stand to be a little bigger, especially if you are wearing gloves. Fyi, there are two smaller internal pockets which can hold a needle nose or a wire stripper nicely. The elastic hold down band is a very neat touch but since the tool holder is a bit wide, the single bungee may not cover the whole area, so maybe two would be a little more secure. The dual D-rings seem a bit much both in size and in quantity, plus I think I'd rather have the "D" pointing down instead of to the sides. There is a little retro-reflective accent on top but would rather it be at the bottom as the top can get covered by clothing or a vest. And in Ergodyne fashion, little details are observed such as a air/drain hole at the bottom.
Please Note: This review is of product that was provided to the user free of charge.
