Squids 3740 Hand Tool Attachment Trap - Slips
Squids 3740 Hand Tool Attachment Trap - Slips
- MEETS THE ANSI/ISEA 121-2018 STANDARD - Third party certified to an 1lb // 0.45kg maximum working capacity
- RETROFIT TOOL ATTACHMENT POINT - Designed to install onto small hand tools to create a tool attachment point for tethering
- ONE-PIECE DESIGN - Easily slides onto small hand tools without requiring additional tools to install or complicated wrapping or shrinking to apply
- NON-CONDUCTIVE - For safety when working around electrical environments
- SWIVELING EXTERIOR RING - Spins 360-degrees allowing screwdrivers and other rotating tools to be used without issue
- DURABLE - ABS outer ring provides strength and durability in all environments, testing in hot, cold and wet conditions
- FLEXIBLE GRIP - Inner core grips tool after application securing it as an attachment point for a tool lanyard preventing dropped objects
- MULTIPLE SIZES - Available in four sizes compatible with tools ranging from 0.05” (1.3mm) to ½” (12.5mm)
- ONE TIME USE - Intended for single use, discard after removal and replace
California Residents: read Proposition 65 .
Product Description
Squids 3740 Hand Tool Attachment Slips (4-Pack) install onto small hand tools to create a retrofit attachment point for tethering tools up to 1lb // 0.45kg, preventing dropped or falling objects from occurring on the job. Connection points for tool lanyards can be tricky to find, especially on smaller hand tools like screwdrivers and hex keys (Allen wrenches). While working at-heights, it is important to tether tools as part of your overall fall protection plan, but the lack of these connection points can make that difficult.
STRAIGHTFORWARD INSTALLATION
The Slips design requires a simple installation that follows its name. Simply “slip” the tool attachment on to the tool and connect a Squids Tool Lanyard to complete your tethering system. Unlike competitors that offer a fitted cap that can cover up information (like on the end of a screwdriver, for example) these solutions leave the end open. The single piece design is easier to install compared to competitors that require two to three pieces to be assembled onto the tool.
Simply puncture the interior membrane of the Tool Slip and slide the attachment to the desired location. The star points of the attachment’s interior will hold its location and the swiveling exterior ring will provide a connection point for tool lanyards.
TESTED TO BE TRUSTED
These tool tether attachments are built to withstand defined weight limits and can easily be used by any worker to help avoid accidentally dropping objects that could cause damage, injuries or possibly death. These attachments are third-party certified to 1lb // 0.45kg maximum capacity based on their diameter and meet the ANSI/ISEA 121-2018 standard with all required labeling.
Ideal for those tethering tools in construction, telecommunications, oil and gas, power generation, utilities, wind energy, manufacturing or other jobsites where dropped objects are a risk.
Four sizes of Slips are compatible on tools with diameters ranging from 0.05” (1.3mm) to ½” (12.5mm). Check out the size chart for specific ranges per size.
Compare With Similar Products
|